DIY Guide: Making a Vanity Table From a Used Dining Table

Having a unrealness table in the bedroom is to a high degree practical; they make storing makeup and other grooming necessities easier. As unsubstantialness tables with mirrors can be a fragment expensive, here is a cheap DIY conductor to make one from an going to decay dining table.

1. Measure the width, depth, and height of the space where you want to install the t. Measure the height of the seat of authority you intend to use from the cover with a, and add four more inches on top of it so that you will have enough space to tuck you feet comfortably subordinate to the vanity set.

2. After the mensuration is done, find an old dining provision of your preference. This used appliances can be found at a reduced excellence at garage sales, flea markets, or archaic stores. As long as the breadth and height of the table give in marriage your measurement, do not worry hither and thither its length as you will exist able cut it to suit the required penetration.

3. Cut the table along its longitudinal dimensions until its width suits the perspicacity of the space where it of necessity to be, leaving it with brace remaining legs. Use a circular axiom so that you will get a near cut. Sand the edges of the plank to remove rough edges.

4. Paint or shame the table if you want to vary its look. Use pastel or floral patterns despite feminine touch, a mahogany or recondite cherry stain for classic look, or burnished colors for a cheery mood.

5. Once coloring is executed, you want to install the unsubstantialness against the wall. Attach a strip of wood under the back of the legless piece and secure with some screws. As the council is attached to the table, you can now fasten the board to the wall. Make ly to screw the board against the prop to have a steady and immovable vanity.

6. If you want skirting around the vanity, measure the sides of the list excluding the part attached to the wall while well as the height from the excel to the floor. Add a hardly any inches of measurement to the skirting-board fabric, cut it in half, and work with needle and thread all four hems of each work. Attach a part of the skirting from the back to the brass of one side of the vanity and do the same with the other sect. This will make the seams of every one part gather in front. Use Velcro tape or upholstery tacks to append the fabric to the sides of the stand.

7. Find a mirror big enough with a view to your vanity table and install it counter to the wall right above the worthlessness. Match the mirror's frame to the semblance of the table.